Cisco 200-301日常練習試験は2022年最新のに更新された190問あります [Q77-Q91]

77、Refer to the exhibit.

An engineer is required to verify that the network parameters are valid for the users wireless LAN connectivity on a /24 subnet. Drag and drop the values from the left onto the network parameters on the right. Not all values are used.

78、What tab contains access point configuration in the WCS?

79、Refer to the exhibit.

Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

80、Refer to the exhibit.

The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2, while all other VLANs are to remain tagged.
Which command accomplishes this task?

81、Refer to the exhibit.

An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.

82、Which three statements about DWDM are true? (Choose three)

83、Refer to the exhibit.

PC1 is trying to ping PC3 for the first time and sends out an ARP to S1 Which action is taken by S1?

84、

Refer to the exhibit. How does router R1 handle traffic to 192.168.10.16?

85、Refer to the exhibit.

The show ip ospf interface command has been executed on R1 How is OSPF configured?

86、Which type of IPv6 address is similar to a unicast address but is assigned to multiple devices on the same network at the same time?

87、Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?

88、Refer to the exhibit.

Which two commands when used together create port channel 10? (Choose two.)

89、Refer to the exhibit.

What does router R1 use as its OSPF router-ID?

90、Three switches are connected to one anther via trunk ports.
Assuming the default switch configuration, which switch is elected as the root bridge for the spanning-tree instance of vlan 1?

91、Refer to the exhibit.

An engineer booted a new switch and applied this configuration via the console port. Which additional configuration must be applied to allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password?