2022年08月25日更新されたNACE-CIP2-001トレーニング最新認定問題をゲットCIP Level 2合格目指せ [Q23-Q43]

23、When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

24、From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is:

25、Coating surveys may include which steps?
Select All That Apply:

26、You can use magnifiers to examine all of the following EXCEPT

27、The best choice of instrument for holiday testing of thick film concrete coatings is:

28、The HATE adhesion tester uses

29、You are the NACE Inspector on a project where a stationary floating structure is being coated and you notice a self-smoothing anti-fouling coating has been specified.
This is not a good choice because:

30、Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

31、Thermal Spray coatings provide:

32、Which standards are generally established by private-sector bodies and are available for use by any person or Organization, private or government?

33、External coatings applied to buried pipelines are generally tested for:

34、The coating applicator has ignored a enface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:

35、Corrosion is the reverse process of

36、Which is used to calibrate a pH meter?

37、A failure caused by applying a coating too thinly is known as

38、The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cure of

39、Inspectors perform tests on linings that they may not perform on exterior coatings because

40、When performing inspection in accordance with ASTM D 4138 the Inspector will use:

41、Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

42、In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?

43、When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to: