Cisco 300-620認定ガイドPDFは100%カバー率でリアル試験問題 [Q79-Q94]

79、Which action sets Layer 2 loop migration in an ACI Fabric with a Layer 2 Out configured?

80、The unicast routing feature is enabled on the bridge domain. Which two conditions enable the Cisco ACI leaf to learn a source IP as a local endpoint? (Choose two.)

81、Which two actions extend a Layer 2 domain beyond the ACI fabric? (Choose two.)

82、Which type of policy configures the suppression of faults that are generated from a port being down?

83、Which type of profile needs to be created to deploy an access port policy group?

84、An engineer must configure RADIUS authentication with Cisco ACI for remote authentication with out-of-band management access. Drag and drop the RADIUS configuration steps from the left into the required implementation order on the right. Not all steps are used.

85、Refer to the exhibit.

An engineer must configure an L3Out peering with the backbone network. The L3Out must forward unicast and multicast traffic over the link. Which two methods should be used to configure L3Out to meet these requirements? (Choose two.)

86、Which Cisco APIC configuration prevents a remote network that is not configured on the bridge domain from being learned by the fabric?

87、Drag and drop the Cisco ACI filter entry options from the left onto the correct categories on the right indicating what are required or optional parameters.

88、A Solutions Architect is asked to design two data centers based on Cisco ACI technology that can extend L2/ L3, VXLAN, and network policy across locations. ACI Multi-Pod has been selected. Which two requirements must be considered in this design? (Choose two.)

89、What do Pods use to allow Pod-to-Pod communication in a Cisco ACI Multi-Pod environment?

90、What is the minimum number of APICs does Cisco recommend to deploy in a production cluster?

91、An engineer is configuring a VRF for a tenant named Cisco. Drag and drop the child objects on the left onto the correct containers on the right for this configuration.

92、A network engineer is integrating a new Hyperflex storage duster into an existing Cisco ACI fabric The Hyperflex cluster must be managed by vCenter so a new vSphere Distributed switch must be created In addition the hardware discovery must be performed by a vendor-neutral discovery protocol Which set of steps meets these requirements’?

93、What do Pods use to allow Pod-to-Pod communication in a Cisco ACI Multi-Pod environment?

94、Which type of profile needs to be created to deploy an access port policy group?