[2022年10月] 確実合格する有効な方法 Cisco 試験問題集 100-101 試験学習ガイド [Q41-Q60]

Rate this post

[2022年10月] 確実合格する有効な方法Cisco試験問題集で100-101試験学習ガイド

100-101問題集とMeta Certified Digital Marketing Associateトレーニングコースでお客様の合格を楽にさせる学習合格試験問題！

Cisco 100-101 認定試験の出題範囲：

トピック	出題範囲
トピック 1	FacebookとInstagramでビジネスプレゼンスを確立するための手順を特定するシナリオを前提として、適切な広告フォーマットを決定する
トピック 2	広告の作成と管理に使用できるツールの違いを説明するメタキャンペーンの構造を特定する
トピック 3	ビジネス目標をメタキャンペーンの目標に一致させることの重要性を説明するビジネス目標を達成するためのメタキャンペーンの目標を決定する
トピック 4	アプリとサービスのメタファミリーを構成するさまざまな製品を特定するメタピクセルの価値を伝える
トピック 5	キャンペーン、広告セット、および広告レベルで利用可能な設定を特定する広告とページ投稿の違いを特定する
トピック 6	Metaがユーザーデータのプライバシーと一般的な広告ポリシーをどのように保護するかを特定するモバイルクリエイティブのベストプラクティスを特定する
トピック 7	予算と見積もり結果の関係を判断する広告アカウントを設定するプロセスを説明する
トピック 8	キャンペーンの成功を測定する方法を説明するメタが広告に請求する方法と広告が表示される場所を説明する
トピック 9	企業向けのアプリとサービスのメタファミリーの価値提案を伝える広告レポートを通じてキャンペーンの結果を特定する

質問41、 CORRECT TEXT
There are three locations in a school district of a large city: ROUTER -M, ROUTER -W and ROUTER -U. The network connection between two of these locations has already functioned. Configure the ROUTER -M router IP addresses on the E0 and S0 interfaces so that the E0 receives the first usable subnet while the S0 receives the second usable subnet from the network 192.168.160.0/28. Both interfaces would receive the last available ip address on the proper subnet.

Note: The OSPF process must be configured to allow interfaces in specific subnets to participate in the routing process.

質問42、 What is the default administrative distance of OSPF?

100

110

120

質問43、 What does the “Inside Global” address represent in the configuration of NAT?

the summarized address for all of the internal subnetted addresses

the MAC address of the router used by inside hosts to connect to the Internet

a globally unique, private IP address assigned to a host on the inside network

a registered address that represents an inside host to an outside network

質問44、 A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link.

The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?

The OSPF area is not configured properly.

The priority on R1 should be set higher.

The cost on R1 should be set higher.

The hello and dead timers are not configured properly.

A backup designated router needs to be added to the network.

The OSPF process ID numbers must match.

質問45、 Refer to the exhibit.

What must be configured to establish a successful connection from Host A to switch SW-A through router RT-A?

VLAN 1 on RT-A

IP routing on SW-A

default gateway on SW-A

crossover cable connecting SW-A and RT-A

質問46、 Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.)
Router(config)# router ospf 1

All OSPF routers in an area must have the same process ID.

Only one process number can be used on the same router.

Different process identifiers can be used to run multiple OSPF processes

The process number can be any number from 1 to 65,535.

Hello packets are sent to each neighbor to determine the processor identifier.

質問47、 What two things does a router do when it forwards a packet? (Choose two.)

switches the packet to the appropriate outgoing interfaces

computes the destination host address

determines the next hop on the path

updates the destination IP address

forwards ARP requests

質問48、 Which layer of the OSI model controls the reliability of communications between network devices using flow control, sequencing and acknowledgments?

Physical

Data-link

Transport

Network

There are many services that can be optionally provided by a transport-layer protocol, and different protocols may or may not implement them. Connection-oriented communication: It is normally easier for an application to interpret a connection as a data stream rather than having to deal with the underlying connection-less models, such as the datagram model of the User Datagram Protocol (UDP) and of the Internet Protocol (IP). Byte orientation: Rather than processing the messages in the underlying communication system format, it is often easier for an application to process the data stream as a sequence of bytes. This simplification helps applications work with various underlying message formats. Same order delivery: The network layer doesn’t generally guarantee that packets of data will arrive in the same order that they were sent, but often this is a desirable feature. This is usually done through the use of segment numbering, with the receiver passing them to the application in order. This can cause head-of-line blocking. Reliability: Packets may be lost during transport due to network congestion and errors. By means of an error detection code, such as a checksum, the transport protocol may check that the data is not corrupted, and verify correct receipt by sending an ACK or NACK message to the sender. Automatic repeat request schemes may be used to retransmit lost or corrupted data. Flow control: The rate of data transmission between two nodes must sometimes be managed to prevent a fast sender from transmitting more data than can be supported by the receiving data buffer, causing a buffer overrun. This can also be used to improve efficiency by reducing buffer underrun. Congestion avoidance: Congestion control can control traffic entry into a telecommunications network, so as to avoid congestive collapse by attempting to avoid oversubscription of any of the processing or link capabilities of the intermediate nodes and networks and taking resource reducing steps, such as reducing the rate of sending packets. For example, automatic repeat requests may keep the network in a congested state; this situation can be avoided by adding congestion avoidance to the flow control, including slow-start. This keeps the bandwidth consumption at a low level in the beginning of the transmission, or after packet retransmission. Multiplexing: Ports can provide multiple endpoints on a single node. For example, the name on a postal address is a kind of multiplexing, and distinguishes between different recipients of the same location. Computer applications will each listen for information on their own ports, which enables the use of more than one network service at the same time. It is part of the transport layer in the TCP/IP model, but of the session layer in the OSI model.

質問49、 What is the best practice when assigning IP addresses in a small office of six hosts?

Use a DHCP server that is located at the headquarters.

Use a DHCP server that is located at the branch office.

Assign the addresses by using the local CDP protocol.

Assign the addresses statically on each node.

質問50、 Which IOS command is used to initiate a login into a VTY port on a remote router?

router# login

router# telnet

router# trace

router# ping

router(config)# line vty 0 5

router(config-line)# login

質問51、 What can public figures, businesses, brands, organizations and nonprofits create on Facebook to establish a presence and connect with an audience?

Event

Profile

Page

Group

質問52、 Refer to the exhibit.

SwitchA receives the frame with the addressing shown. According to the command output also shown in the exhibit, how will SwitchA handle this frame?

It will drop the frame.

It will forward the frame out port Fa0/6 only.

It will flood the frame out all ports.

It will flood the frame out all ports except Fa0/3.

質問53、 CORRECT TEXT

Which two of the following are true regarding the configuration of RouterA? (Choose two.)

at least 5 simultaneous remote connections are possible

only telnet protocol connections to RouterA are supported

remote connections to RouterA using telnet will succeed

console line connections will nevertime out due to inactivity

since DHCP is not used on FaO/1 there is not a need to use the NAT protocol

質問54、 An e-commerce company launches a new website. The company wants to build a campaign that optimizes for the audience to take a specific action when visiting the website.
Which campaign objective should the company use to accomplish this goal?

Conversions

Engagement

Reach

Traffic

質問55、 Refer to the exhibit.

If the resume command is entered after the sequence that is shown in the exhibit, which router prompt will be displayed?

Router1>

Router1#

Router2>

Router2#

質問56、 Which three approaches can be used while migrating from an IPv4 addressing scheme to an IPv6 scheme? (Choose three)

static mapping of IPv4 address to IPv6 addresses

configuring IPv4 tunnels between IPv6 islands

use DHCPv6 to map IPv4 addresses to IPv6 addresses

use proxying and translation (NAT-PT) to translate IPv6 packets into IPv4 packets

configure IPv6 directly

enable dual-stack routing

質問57、 Given an IP address of 192.168.1.42 255.255.255.248, what is the subnet address?

192.168.1.8/29

192.168.1.32/27

192.168.1.40/29

192.168.1.16/28

192.168.1.48/29

質問58、 DRAG DROP

質問59、 Refer to the exhibit.

SwitchA receives the frame with the addressing shown. According to the command output also shown in the exhibit, how will SwitchA handle this frame?

It will drop the frame.

It will forward the frame out port Fa0/6 only.

It will flood the frame out all ports.

It will flood the frame out all ports except Fa0/3.

質問60、 Refer to the exhibit.

Host A is sending a packet to Host B for the first time. What destination MAC address will Host A use in the ARP request?

192.168.0.1

172.16.0.50

00-17-94-61-18-b0

00-19-d3-2d-c3-b2

ff-ff-ff-ff-ff-ff

255.255.255.255

最新 [2022年10月] 効果的な学習法で試験合格できる100-101：https://www.goshiken.com/Cisco/100-101-mondaishu.html

Tags: 100-101テストトレーニング, 100-101受験対策書, 100-101合格率, 100-101基礎問題集, 100-101専門知識内容, 100-101資格練習

[2022年10月] 確実合格する有効な方法 Cisco 試験問題集 100-101 試験学習ガイド [Q41-Q60]

Cisco 100-101 認定試験の出題範囲：

コメントを残すコメントをキャンセル

関連認証

100-101 練習テスト

最近の投稿

アーカイブ

カテゴリー

[2022年10月] 確実合格する有効な方法 Cisco 試験問題集 100-101 試験学習ガイド [Q41-Q60]

Cisco 100-101 認定試験の出題範囲：

コメントを残す コメントをキャンセル

関連認証

100-101 練習テスト

最近の投稿

アーカイブ

カテゴリー

コメントを残すコメントをキャンセル