NSE7_EFW-7.0無料試験学習ガイド！（更新された122問あります) [Q53-Q73]

質問 53
Examine the following partial output from two system debug commands; then answer the question below.

Which of the following statements are true regarding the above outputs? (Choose two.)

質問 54
Examine the output from the ‘diagnose vpn tunnel list’ command shown in the exhibit; then answer the question below.

Which command can be used to sniffer the ESP traffic for the VPN DialUP_0?

質問 55
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.

Why didn’t the tunnel come up?

質問 56
Refer to the exhibit, which contains the partial output of the get vpn ipsec tunnel details command.

Based on the output, which two statements are correct? (Choose two.)

質問 57
Examine the following partial output from a sniffer command; then answer the question below.

What is the meaning of the packets dropped counter at the end of the sniffer?

質問 58
An administrator is running the following sniffer in a FortiGate:
diagnose sniffer packet any “host 10.0.2.10” 2
What information is included in the output of the sniffer? (Choose two.)

質問 59
An administrator cannot connect to the GIU of a FortiGate unit with the IP address 10.0.1.254. The administrator runs the debug flow while attempting the connection using HTTP.
The output of the debug flow is shown in the exhibit:

Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)

質問 60
Refer to the exhibit, which contains the partial output of a diagnose command.

Based on the output, which two statements are correct? (Choose two.)

質問 61
View the exhibit, which contains the partial output of a diagnose command, and then answer the question below.

Based on the output, which of the following statements is correct?

質問 62
View the exhibit, which contains a session entry, and then answer the question below.

Which statement is correct regarding this session?

質問 63
The CLI command set intelligent-mode <enable | disable> controls the IPS engine’s adaptive scanning behavior .
Which of the following statements describes IPS adaptive scanning?

質問 64
Refer to the exhibit, which contains the partial output of a diagnose command.

Based on the output, which two statements are correct? (Choose two.)

質問 65
View the exhibit, which contains the output of a debug command, and then answer the question below.

What statement is correct about this FortiGate?

質問 66
Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statement can explain why the state of the remote BGP peer 10.200.3.1 is Connect?

質問 67
Refer to the exhibit, which contains a TCL script configuration on FortiManager.

質問 68
An LDAP user cannot authenticate against a FortiGate device.
Examine the real time debug output shown in the exhibit when the user attempted the authentication; then answer the question below.


Based on the output in the exhibit, what can cause this authentication problem?

質問 69
Which two statements about FortiManager is true when it is deployed as a local FDS? (Choose two.)

質問 70
View the exhibit, which contains the output of a diagnose command, and then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

質問 71
View the exhibit, which contains the output of a diagnose command, and then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

質問 72
Refer to the exhibit, which shows a session entry .

Which statement about this session is true?

質問 73
Which of the following statements are true regarding the SIP session helper and the SIP application layer gateway (ALG)? (Choose three.)