有効な156-585テスト解答CheckPoint 156-585試験PDF問題を試そう [Q10-Q30]

新問題 10
Which situation triggers an IPS bypass under load on a 24-core Check Point appliance?

新問題 11
What process monitors, terminates, and restarts critical Check Point processes as necessary?

新問題 12
If the cpsemd process of SmartEvent has crashed or is having trouble coming up. then it usually indicates that___________.

新問題 13
In Security Management High Availability, if the primary and secondary managements, running the same version of R80.x, are in a state of ‘Collision’, how can this be resolved?

新問題 14
Where will the usermode core files be located?

新問題 15
You need to runa kernel debug over a longer period of time as the problem occurs only once or twice a week.
Therefore you need to add a timestamp to the kernel debug and write the output to a file What is the correct syntax for this?

新問題 16
For TCP connections, when a packet arrives at the Firewall Kernel out of sequence or fragmented, which layer of IPS corrects this to allow for proper inspection?

新問題 17
Troubleshooting issues with Mobile Access requires the following:

新問題 18
What are the four ways to insert an FW Monitor into the firewallkernel chain?

新問題 19
The Check Pom! Firewall Kernel is the core component of the Gaia operating system and an integral part of the traffic inspection process There are two procedures available for debugging the firewall kernel Which procedure/command is used for troubleshooting packet drops and other kernel activites while using minimal resources (1 MB buffer)?

新問題 20
VPN issues may result from misconfiguration, communication failure, or incompatible default configurations between peers Which basic command syntax needs to be used fortroubleshootingSite-to-Site VPN Issues?

新問題 21
When a User Mode process suddenly crashes it may create a core dump file. Which of the following information is available in the core dump and may be used to identify the root cause of the crash?
i Program Counter
ii Stack Pointer
ii. Memory management information
iv Other Processor and OS flags / information

新問題 22
You are running R80.XX on an open server and you see a high CPU utilization on your 12 CPU cores You now want to enable Hyperthreading to get more cores to gain some performance. What is the correct way to achieve this?

新問題 23
How can you start debug of the Unified Policy with all possible flags turned on?

新問題 24
What is the proper command for allowing the system to create core files?

新問題 25
Select the technology that does the following actions
– provides reassembly via streaming for TCP
– handles packet reordering and congestion
– handles payload overlap
– provides consistent stream of data to protocol parsers

新問題 26
Which command is most useful for debugging the fwaccel module?

新問題 27
What command sets a specific interface as not accelerated?

新問題 28
You are running R80.XX on an open server and you see a high CPU utilization on your 12 CPU cores You now want to enable Hyperthreading to get more cores to gain some performance. What is the correct way to achieve this?

新問題 29
What process is responsible for sending and receiving logs in the management server?

新問題 30
You need to run a kernel debug over a longer period of time as the problem occurs only once or twice a week. Therefore you need to add a timestamp to the kernel debug and write the output to a file What is the correct syntax for this?