本日更新の2023年11月試験エンジンとPDF NACE-CIP2-001テスト無料！ [Q34-Q50]

新問題 34
Centrifugal blast cleaning requires:

新問題 35
Which surface preparation method uses a dilute acid solution to remove laitance and I roughen the concrete surface?

新問題 36
WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)

新問題 37
When a coating is expected to be exposed to temperatures above 93C (200 F) the best choice would be:

新問題 38
Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

新問題 39
Which standards are generally established by private-sector bodies and are available for use by any person or Organization, private or government?

新問題 40
Which is used to calibrate a pH meter?

新問題 41
An Inspection and Test Plan is required when:

新問題 42
Which concrete smoothing technique involves scrubbing a mixture of cement mortar over the concrete surface using ai cement sack, gunny sack, or sponge rubber float?

新問題 43
The cost of qualified Coating Inspection is normally offset by:

新問題 44
External coatings applied to buried pipelines are generally tested for:

新問題 45
When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

新問題 46
A reinforced coating is

新問題 47
Surface preparation methods for Non-ferrous metals are:

新問題 48
You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to:

新問題 49
The most likely area of failure on a buried external pipeline coating is the:

新問題 50
Cold-applied tape