[Q23-Q39] 100%合格率保証付きで最高のE_S4CON_2505試験でリアル問題PDFがある[2026年08月]

質問23、 You are running an SAP ECC system .
For which of the following activities does SUM allow you to use the near-Zero Downtime Maintenance (nZDM) capabilities? Note: There are 3 correct answers to this question.

質問24、 What SAP systems can you use for the ABAP Test Cockpit (ATC) to perform the custom code analysis for an SAP S/4HANA conversion? Note: There are 2 correct answers to this question.

質問25、 You are planning an SAP S/4HANA conversion.
Which conversion-specific tasks must be performed during the preparation phase?

質問26、 You are running an SAP ECC system with SAP BASIS 740, non-Unicode on SAP MaxDB. Which of the following are possible paths to perform an SAP S/4HANA conversion? Note: There are 3 correct answers to this question.

質問27、 You are performing an SAP S/4HANA conversion with scenario strategy Standard. Which phases are executed during SUM technical downtime? Note: There are 2 correct answers to this question.

質問28、 Which preoperational steps must be performed for an SAP S/4HANA conversion? Note: There are 2 correct answers to this question.

質問29、 You performed a custom code check for an SAP S/4HANA conversion.
In which transactions can you review the results? Note: There are 2 correct answers to this question.

質問30、 You are using DMO of SUM. You defined 40 parallel R3load processes during uptime and 80 parallel R3load processes during downtime. You have chosen table count verification, but not table contents comparison.
Phase EU_CLONE MIG_DT_RUN is running In the Charts Control Center, you can see 400 process buckets being executed in parallel.
Why are 40 Process Buckets executed in parallel?

質問31、 What is the main purpose of performing benchmark runs for an SAP S/4HANA conversion?

質問32、 Which of the following scenarios does Software Update Manager cover? Note: There are 2 correct answers to this question

質問33、 Which step can be optimized when you provide the MIGRATE_DT_DURXML file to SUMM?

質問34、 What do you need to consider when performing the SI checks for an SAP S/4HANA conversion? Note: There are 2 correct answers to this question.

質問35、 You are performing an SAP S/4HANA conversion.
When does the silent data migration (SDM) take place using the SUM defaults?

質問36、 You have selected “Standard” as scenario strategy in the SUM tool.
Which steps take place via the shadow instance? Note: There are 2 correct answers to this question.

質問37、 You are performing an SAP S/4HANA conversion with the migration repetition option. After which phase does SUM stop to enable a test cycle?

質問38、 Which steps should be performed during the adjustment of dictionary objects (SPDD) in the development system before SUM continues? Note: There are 2 correct answers to this question.